Instructions For Use; Before Initial Operation - Flex RE 16-5 115 Instrucciones De Funcionamiento Originales

Instructions for use

Before initial operation

Unpack the power tool and accessories and
check that no parts are missing or were
damaged during transport.
Operation with protective hood
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
Attaching the protective hood
 Loosen and remove the locking screw (1.).
 Push the protective hood over the pins on
the housing (2.).
 Install the locking screw (3.).
 Remove the protective hood in the reverse
order.
Adjusting the bail handle
22
Attaching the Velcro plate
 Press and hold the spindle lock (1.).
 Screw sanding disc onto the spindle.
 Tighten sanding disc clockwise using
wrench (2.).
 Place sanding tool in the centre of the
Velcro pad .
Attaching the diamond sanding plate
 Press and hold the spindle lock (1.).
 Screw the diamond sanding plate onto the
spindle.
 Tighten the diamond sanding plate with the
wrench in clockwise direction (2.).
RE 16-5 115