Working With The Power Tool - Flex RE 16-5 115 Instrucciones De Funcionamiento Originales

RE 16-5 115
NOTE
If your dust extraction system needs a
special connection (i.e. a connection other
than the 32 mm/36 mm standard connection
included in the items supplied with the power
tool), contact the dust extractor vendor to
obtain a suitable adapter.

Working with the power tool

WARNING!
The rotating grinding/sanding plate must not
come into contact with sharp, protruding
items. Risk of kickback! Grinding/sanding
plate damage. If the grinding/sanding plate is
damaged or heavily worn, it must be
replaced without fail.
CAUTION!
Always hold the power tool firmly with both
hands.
1. Secure the protective hood or guide cowl.
2. Secure the tool/attachment.
3. Adjust the protective hood or guide cowl
to the correct height.
4. Connect a dust extraction system.
5. Insert the mains plug.
6. Perform a test run to check that the tool/
attachment is properly secured.
Switch on the power tool (without detent)
and allow it to run for approx. 30 seconds.
Check for imbalance and vibrations.
7. Set required speed.
8. Switch on dust extraction.
9. Always hold the power tool firmly with
both hands.
Always keep one hand on the power tool so
that the power tool can be switched off
without delay in the event of an emergency.
10. Switch on the power tool.
Using with protective hood:
 Bring the concrete planer into contact with
the work surface.
The brush ring must be flush with the work
surface.
 Increase pressure to bring the abrading
tool into contact with the work surface.
Sweep the concrete planer with
overlapping movements when doing this.
 For sanding in corners:
– Switch off the power tool and wait until
the abrading tool has stopped moving.
– Loosen the clamping screw (1.).
– Move the swivelling edge segment to
the right (2.).
– Tighten the clamping screw (3.)
– Switch the power tool back on again.
25