Nokia N900 Manual De Usuario página 54

54 Mail
For information on the supported secure connections,
contact your mail service provider.
Port — Enter the port number. For details, contact your
mail service provider.
Tip: Usually, the incoming mailbox servers (POP3 or
IMAP4) are provided by your mail service provider, and
the outgoing mail server (SMTP) is provided by your
internet service provider. If these service providers are
different, you may have different passwords and security
settings for incoming and outgoing messages.
6 Simple mail transfer protocol (SMTP) servers are used
when sending mail. To send mail, you must define the
SMTP host name or IP address that you obtain from the
mail service provider of the connection you use.
If you selected Other
the following settings for outgoing mail:
Outgoing server — Enter the host name or IP address
of the server that sends your mail.
Secure authentication — Set the system to use secure
authentication.
Secure connection — Define the security setting for
outgoing messages.
Port — Enter the port number. For details, contact your
mail service provider.
User name and Password — Enter your user name and
password for the SMTP server.
Use connection-specific SMTP servers — Use
connection-specific SMTP servers for sending mail. To
as the mail service provider, define
edit connection-specific SMTP server settings, select
SMTP servers.
Tip: The settings for outgoing mail (SMTP) usually either
use a user name and a password, or are specific to a
connection. Without an SMTP user name and password,
your internet service provider may prevent you from
sending mail for security reasons.
7 To complete the e-mail account setup, select Finish.
Set up a Mail for Exchange account
To be able to use Mail for Exchange, you need a Mail for
Exchange account.
To set up an account:
1 Select E-mail
>
2 Define the following:
Region — Select the correct region.
Service provider — Select
Account title — Enter a title for your account.
3 Define the following:
Mail address — Enter the mail address.
Server — Enter the server address.
Port — Enter the port number for the Mail for Exchange
server connection. The field is pre-filled with the
standard HTTPS Mail for Exchange port number.
Domain — Enter the domain name. This field is not
mandatory.
and New account.
Mail for Exchange.
Edit