Vetus BMON Manual De Manejo Y Instrucciones De Instalación página 17

2.2 Connections
Connect the battery monitor as shown in the wiring diagram, see
page 86.
Fit a switch in the yellow wire. This allows the display to be
switched on or off, while the registration of the charge or dis-
charge current continues.
The shunt resistance supplied is suitable for a maximum
current of 200 A.
A current larger than 200 A will not be measured correctly.
Battery monitor
Note!
3 Working
When the instrument is switched on the voltage is displayed.
There are two push buttons on the instrument (the '<' button and
the '>' button). Another function can be chosen by holding one
of these buttons down for about 2 seconds.
The different LEDs show which function has been activated.
Display
'<' button '>' button
ENGLISH
LEDs
17
9.0422