Flexible Induction Cooking Area; Flexibridge Function - AEG IKE64473IB Manual De Instrucciones

This deactivates automatic operation of the
function and allows you to change the fan
speed manually. When you press
raise the fan speed by one. When you reach
an intensive level and press
set fan speed to 0 which deactivates the
hood fan. To start the fan again with fan
speed 1 touch .
To activate automatic operation
of the function, deactivate the
hob and activate it again.

6. FLEXIBLE INDUCTION COOKING AREA

WARNING!
Refer to Safety chapters.

6.1 FlexiBridge function

The flexible induction cooking area consists
of four sections. The sections can be
combined into two cooking zones with
different size, or into one large cooking area.
You choose the combination of the sections
by choosing the mode applicable to the size
of the cookware you want to use. There are
three modes: Standard (activated
automatically when you activate the hob), Big
Bridge and Max Bridge.
To set the heat setting use two
left side control bars.
Switching between the modes
To switch between the modes use sensor
field: .
When you switch between the
modes the heat setting is set
back to 0.
Diameter and position of the cookware
Activating the light
You can set the hob to activate the light
automatically whenever you activate the hob.
you
To do so set the automatic mode to H1 – H6.
again you will
Choose the mode applicable to the size and
the shape of the cookware. The cookware
should cover the selected area as much as
possible. Place the cookware centrally on the
selected area!
Place the cookware with the bottom diameter
smaller than 160 mm centrally on a single
section.
Place the cookware with the bottom diameter
larger then 160 mm centrally between two
sections.
The light on the hood
deactivates 2 minutes after
deactivating the hob.
100-160mm
ENGLISH 15