Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
114C IM 14Aug06
Application and Removal of Adhesive on Laser
Pod
legs
gs
d
on
1. To apply the adhesive to the unit, follow the steps
outlined in illustration 8.
2. Lower the standoff legs by pressing the release
button (see illustration 6).
3. Make sure that the adhesive plate is centered
so you have clearance to tilt the unit to either
side (see illustration 6).
4. Place the unit on the surface and position it
where required. Press the unit toward the wall
so the adhesive is applied and the legs lock in
the retracted position.
5. To remove the adhesive from the surface and
the laser unit, S S L L O O W W L L Y Y pull on the adhesive tab in
the direction shown.
Note: To assure a continued good bond of the adhesive
to the product, periodically wipe the sliding adhesive
plate (see illustration 6) with a swab dipped in
isopropyl or rubbing alcohol to keep the surface clean.
ILLUSTRATION 8
Remove the release
liner from 1 side.
Avoid touching adhesive.
Apply the 2nd adhesive pad
in the position shown.
8/14/06
7:40 PM
Press the adhesive on to the
laser unit in the position shown.
Use the release liner to press the
adhesive to the unit. Then peel
away second release liner.
–6–
To remove the adhesive from
the surface and laser unit,
slowly pull the tab in the
direction shown.
Page 7
Publicidad
Tabla de contenido
