Stanley IntelliLaser Pro 77-500 Manual De Instrucciones página 9

114C IM 14Aug06
IMPORTANT: The unit can
not be moved before
calibration is complete.
"READY" will appear
on the LCD.
Notes:
1. Laser line is always on when
holding the "ON"
2. Continue to hold the "ON" button during stud
detection.
USAGE OF STUD SENSOR
Selecting depth detection
1. Depress and hold "ON" button once (1x) to select
to 1/2" read depth detection. The 1/2" mode LED
will illuminate (illustration 5). The unit will then
calibrate, followed by a beep and a "READY"
displayed on the LCD.
2. "Double-click"/Depress and hold "ON" button
twice (2x) to select 1" read depth selection. The
1" LED will illuminate (illustration 5). The unit will
then calibrate, followed by a beep and a "READY"
will appear on the LCD.
3. "Triple-click"/ Depress and hold "ON" button three
times (3x) to select 1-1/2" read depth selection.
The 1" LED will illuminate (illustration 5). The unit
will then calibrate, followed by a beep and a
"READY" will appear on the LCD.
Detecting Wood or Metal Studs
1. Once the unit is calibrated, slide the unit across
the surface in a straight line horizontally.
As the unit gets closer to the stud, the cross will
appear and the indicator rings will illuminate in
8/14/06 7:40 PM
ILLUSTRATION 9
button.
–8–
Page 9