Signalling Led - Allmatic BIOS1 24V Manual Del Usuario

5.3 - MALFUNCTION SIGNALLINGS
DISPLAY
eme
eex
eLs
RELAY 4
efO
eeD
RELAY 3
eph
eth
fuL
err
NOTE - The visualization of an error on the display persists until the "DOWN" button is pressed or until another command is given.
WARNING - the restore from an EEx error must be carried out through one of the 3 buttons of the control unit (UP, MENU or DOWN).

5.4 - SIGNALLING LED

RELAY 2
RELAY 1
+24VDC
OGL GND
+24VDC TX PHOTO
1-2: FLASH
3 4 5 6 7
LED
EDGE
PH2
PH1
STOP
OPEN
CLOSE
PED
SS
LS1
LS2
RADIO
POWER ON
8/20
DESCRIPTION
Memory error: the external memory not installed or not recognised.
Memory error during the writing: the value x is a number from 1 to 6. In the event of the error, contact the technical assistance.
Limit switches error: opening and closing limit switches are busy in the same time
Impact sensor intervention.
POWER
Safety edge intervention.
Malfunctioning of photocells.
Thermical intervention to preserve the control unit.
Full external memory.
Memory error during functions viewing memory location or cancellation of a single transmitter.
25 +
26 -
J5
ON DIP-SWITCH
EDGE PH2
PE
8 9 10 11
COLOUR DESCRIPTION
RED Safety signalling, Led normally ON.
RED Safety signalling, Led normally ON.
RED Safety signalling, Led normally ON.
RED Safety signalling, Led normally ON.
GREEN Led normally OFF. It is turned on when the button is pressed.
GREEN Led normally OFF. It is turned on when the button is pressed.
GREEN Led normally OFF. It is turned on when the button is pressed.
GREEN Led normally OFF. It is turned on when the button is pressed.
RED Led is turned on when the limit switch is not activated.
RED Led is turned on when the limit switch is not activated.
RED Led ON with a radio transmission or interferences.
GREEN Led normally ON. It shows the presence of the power supply.
DISPLAY
ON
UP DOWN
MENU
SS
PH1 STOP OPEN CLOSE PED SS
12 13 14 15 16 17
ITA ENG FRA ESP
22
21
J3
J4
J2
RADIO
COM LS1 LS2
18 19 20
6-1622400
FIG. 5
rev.03 07/09/2018