Tabla de contenido
Publicidad
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
Inspect the showerpipe for shipping
damage before installation.
for shipping damage made after the
showerpipe is installed will not be
honored.
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• This showerpipe requires showerpipe rough
16181181(not included).
• Do not install this showerpipe in a steam shower.
• Make sure that the wall is strong enough to
support the showerpipe. The wall must be
reinforced at the mounting points. The area
where the top mounting piece is to be installed
Product Safety Notes
• The purpose of the shower arm is to support the
showerhead only. Do not use it to support other
objects.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
158°F (70° C)*
must be flat and free of protruding grout joints,
etc.
Claims
• The enclosed screws and anchors are suitable for
a solid surface wall. For other wall constructions,
select mounting hardware and reinforcement
suitable for that specific construction.
• This showerpipe is for use with shower heads
rated at 1.5 GPM (5.7 l/min) or higher.
• Protection against backflow is provided by
check valves.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts,
the maximum output temperature can be no
higher than 112°F (44°C).
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product
in a safe place. The receipt is required should it
be necessary to request warranty parts.
• Do not use the showerpipe as a grab bar. Using
the showerpipe as a grab bar may result in injury
or product damage. If a grab bar is required,
purchase and install one separately.
This unit meets or exceeds the
following:
• ASME A112.18.1 / CSA B125.1
• Listed by IAPMO for use in the
US and Canada
Publicidad
Tabla de contenido
