Schlage Control FE410F Instrucciones De Instalación página 6

3
Install the bottom part of the lock.
3a Install the handing plate into the lever assembly.
If the handing plate is not in the correct position, locking and
unlocking could be reversed, resulting in an unsecured residence.
See Determine the Handing
L
on page 2 to determine
the hand of your door.
1. Rotate the assembly so
the notch faces the latch
Left hand
2. Place the handing plate in the correct position.
Press handing plate all the way into the chassis.
3b Install the lever assembly on the outside of the door.
Make sure the notch
faces the latch. See
step 3a.
The lever will be installed later.
L
3c Secure the inside assembly with the two bottom screws.
CAUTION
Right hand
OR
Actual Size (2)
3d Move the handing screw and cam stop to the appropriate
position, if necessary.
See Determine the Handing on page 2 to determine the
L
hand of your door.
If the handing screw is not in the correct position, locking and
unlocking could be reversed, resulting in an unsecured residence.
Handing screw
Left hand
position
4
Apply power to the lock.
4a Connect the cable to the inside assembly.
CAUTION
OR
and cam stop
Red wire
The connector fits only one
way. DO NOT FORCE!
Right hand
position
5