Wet Grinding - Husqvarna HTC 5 Serie Manual De Usuario

HTC T5
Switch off the Mist Cooler System by
pressing the Mist Cooler System button on
the control panel. See Control panel (HMI)
page 22 position 8.

7.1.2 Wet grinding

Wet grinding with water is used when grinding difficult to grind floors. It is also used to obtain
a greater performance or lower temperature during grinding.
Grinding
Set the handle to the working position. See
page 30.
Connect the water using the quick release
coupling on the rear of the machine. For
pressure and maximum flows, see Technical
Data page 56.
An electrically controlled proportional valve
controls the water flow.
44
NOTE
Make sure the water supply is only on during grinding. Always
use liquid suction when wet grinding.
Accessories
D004753, 01.01