To Connect The Product To A Power Source; Operation Speed; Direction Of Rotation Of The Grinding Discs; To Operate The Product - Husqvarna PG 830S Manual Del Usuario

4. Loosen the 4 screws (C) on the handlebar.
D
C
5. Adjust the handlebar (D) to an applicable operation
height.
6. Tighten the 4 screws (E) on the handlebar to lock the
handlebar position.
To connect the product to a power
source
1. Connect the power plug of the product to the
extension cable.
2. Connect the extension cable to a mains outlet.
3. Engage the support frame. Refer to
disengage the support frame on page 10 .
4. Hang the power cord on the suspension device on
the support frame to prevent tension in the power
cord.
5. Disengage the support frame.
CAUTION: When the product is connected
to a dust extractor, the dust extractor must
be connected to a 3-phase power source.
14
E
To engage and

Operation speed

If the product is operated on a new surface type, set the
speed to 70% initially. When the operator knows the
surface type, the speed can be adjusted.
Direction of rotation of the grinding
discs
Seen from below the product, the direction of rotation is
as follows:
• "CW": clockwise
• "CCW": counterclockwise
During operation the product can pull to the side. The
direction of the pull is related to the direction of rotation.
The product pulls to the right when the direction of
rotation is set to "CCW". The product pulls to the left
when the direction of rotation is set to "CW".
The side pull can help you operate the product for
example near a wall. Set the direction of rotation to pull
in the direction of the wall.
CAUTION: Steer the product carefully. Make
sure that the product only lightly touches the
wall. The product is heavy and can cause
damage.
To change the speed and direction of rotation
of the motor
Change the direction of rotation regularly to increase the
life and the sharpness of the diamond tools. The
diamond tool segments are used equally and the contact
surface continues to be as large as possible.
• To set the speed and direction of rotation of the
grinding disc, turn the knob.

To operate the product

• Operate the product manually with the control panel
on the handle. Refer to
on page 4 .
Product overview, left side
1253 - 003 - 22.01.2020