The Mist Cooler System; To Operate The Product With Wet Grinding; To Operate The Product With The Mist Cooler System - Husqvarna DURATIQ XP6 Manual Del Usuario

6. Turn the battery switch counterclockwise.

The Mist Cooler System

The Mist Cooler System decreases the temperature of
the grinding disc tools and makes the performance of
the product better. The Mist Cooler System uses the
water from the water tank. The nozzle of the Mist Cooler
System supplies the water on the surface.
To operate the product with the Mist Cooler
System
1. Start the engine. Refer to
control panel on page 19 .
2. Fill the water tank with water if the water level is low.
To fill the water tank with water on page
Refer to
26 .
1268 - 002 - 25.05.2020
To start the product with
3. Push the button for Mist Cooler System (A) on the
control panel. The indicator for Mist Cooler System
(B) in the display comes on when the system is on.
B
4. When the operation is completed, the Mist Cooler
System stops automatically. You can also push the
button for Mist Cooler System on the control panel to
stop the Mist Cooler System.
To operate the product with wet
grinding
Always use liquid suction when wet grinding.
1. Start the engine. Refer to
control panel on page 19 .
2. Connect a water hose to the water release coupling
on the product. Refer to
water hose on page 18 .
3. Push the water supply button (A) on the control
panel. The water supply indicator (B) in the display
comes on when the system is on.
B
4. Push the increase/decrease button for water supply
(C) to increase (+) or decrease (-) the water flow.
The gauge in the display shows the water flow
between 1-100% (D).
To start the product with
To connect the product to a
D
12.9 V
A
A
C
21