Blowing Operation - EWT CS 3 COMFORT Manual De Instrucciones

vacuumed along with the liquid.
The appliance is fitted with a float switch which blocks
vacuuming when the container is full. You can tell when
vacuuming stops because the motor turns faster. If this
happens, stop the appliance immediately and disconnect from
the mains. Take into account that a full container can be very
heavy. Remove the upper part of the container and pour the
liquid into a suitable recipient or into a runoff. You can then
continue vacuuming once you have reinstalled the upper part.
After vacuuming liquids, stop the appliance and
disconnect from the mains. Empty the container and clean and
dry it on the inside and the outside before storing it.
Reminder! The foam filter should be removed after vacuuming
liquids and a dust filter installed before starting to vacuum dry
waste.

BLOWING OPERATION

2 3
1 4
1. Push the large end of the flexible hose into the blower connection in the top of the motor housing
(Fig. 1).
2. Ensure the power switch is turned off and plug into the power supply (Fig. 2).
3. Switch on the power (Fig. 3).
4. The unit will now blow through the vacuum hose, and can be used to clear obstructions within the pipe
(Fig. 4).
WARNING! If the hose is still blocked after a few seconds, turn
off the unit and clear the hose manually.
38