Sauder Carson Forge 415117 Manual De Usuario página 14

Step 9 Step
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (N2) and lay it over your unit.
Make equal margins along along the two short edges and along
å
the two long edges of the BACK (N2). Push on opposite corners
of your unit if needed to make it "square".
Fasten the BACK (N2) to your unit using the NAILS (1N).
å
Push four FEET (10E) onto the LEGS (G, H, and I).
å
With a hammer, gently tap four TACK GLIDES (12E) through the
å
holes of the FEET (10E).
10E
G
10E
12E
Page 14
1N
NAIL
(40 used in this step)
I
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
This hole should
line up over the
screw head.
N2
I
10E
H
10E
415117
Caution
This perforation
must be here.
www.sauder.com/services