Sauder Carson Forge 415117 Manual De Usuario página 15

Step 10 Step
1
D132
Groove
Insert the LARGE DRAWER SIDES (D132 and D138)
å
at an angle into the slot at each end of the LARGE
DRAWER FRONT (J).
3
M65
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M65) to the LARGE
å
DRAWER FRONT (J). Tighten one HIDDEN CAM.
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
J
D138
Maximum
Arrow
210 degrees
Minimum
190 degrees
J
VIEW THE T-LOCK BOX VIDEO
2
U n
fi n
s u
i s h
r f a
e d
c e
D132
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D980) into the grooves
å
in the LARGE DRAWER SIDES (D132 and D138) and
LARGE DRAWER FRONT (J).
4
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D132
M65
Fasten the LARGE DRAWER BACK (D171) to the
å
LARGE DRAWER SIDES (D132 and D138) and DRAWER
BRACE (M65). Use five BLACK 1-9/16" FLAT HEAD
SCREWS. Repeat this step for the remaining drawers.
415117
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D980
J
D138
30S
(20 used in this step)
D171
Be sure the
D138
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 15