Turn Off The Appliance; Transport; Storage; Frost Protection - Kärcher HD 9/21 G Manual De Instrucciones

Turn off the appliance

After operating the water using saline water
(sea water), open the hand spray gun and
rinse the appliance for at least 2 - 3 minutes
using tap water.
 Close the hand spray gun.
 Turn the starter to "0/OFF".
 Close fuel cock.
 Shut off water supply.
 Activate trigger gun until device is pres-
sure-less.
 Secure the trigger gun. To do so, push
the safety catch towards the front.
 Remove the water inlet hose from the
appliance.

Transport

CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
ATTENTION
Protect the trigger from damage during
transport.
 Coil the high-pressure hose and hang it
over the hose storage.
 Insert the spray lance into the spray
lance cart.
Place the trigger gun into the holder.
 Use the pushing handle to push the ap-
pliance.
 When transporting in vehicles, secure
the device according to the guidelines
from rolling away, slipping and tipping
over.
 To reduce the space requirement, loos-
en the star grips and swivel the push
handle backwards.

Storage

CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.
This appliance must only be stored in inte-
rior rooms.

Frost protection

ATTENTION
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
In the winter, preferably store the device in
a heated room
If storing it in unheated rooms, follow these
instructions:
Drain water
 Screw off water supply hose and high
pressure hose.
 Operate device for max. 1 minute until
the pump and conduits are empty.
 Unscrew the water filter and empty it.
Flush device with anti-freeze agent
Note: Observe handling instructions of the
anti-freeze agent manufacturer.
 Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.

Care and maintenance

You can sign with your dealer a contract for
regular safety inspection or even sign a
maintenance contract. Please take advice
on this matter.
Note: The maintenance plan given below
only lists the maintenance tasks for the
high-pressure pump. The maintenance
tasks for the engine must also be done ac-
cording to the details given in the operating
instructions manual of the engine manufac-
turer.
DANGER
Risk of injury if the machine is left running
in an unattended state.
Before working on the device, turn the start-
er to "0/OFF" and remove the spark plug
connector.
Risk of burns! Do not touch hot mufflers,
cylinders or radiator ribs.
– 7
EN 23