Paslode T250S-F16P Operating Manual página 6

TOOL OPERATION
Trigger Methods:
The Paslode T250S-F16P Finish Nailer has a triggering
system than can be switched from sequential to contact
trip. T o switch the trigger, press in the round button
on the left side of the trigger and rotate the right side
of the button to the desired triggering method. The TTT
indicates contact trip and the T indicates sequential
operation.
Successive (Bounce) Driving -
Grasp the handle firmly.
Squeeze the trigger and move the tool along the work-
piece with a bouncing motion, depressing the work con-
tacting element at the points where you want to drive a
fastener.
Keep the trigger depressed and continue to bounce the
work contacing element against the workpiece, position-
ing the tool above as carefully as possible.
When the desired number of fasteners have been
driven, release the tool trigger to avoid unintentional
fastener discharge.
Trigger select
indicator
Sequential Operation -
The sequential setting T prevents succesive or "bounce"
driving.
Depress the work contacting element and hold it
against the work surface before pulling the trigger.
After each fastener is driven, completely release the
trigger and lift the tool from the work surface.
Successive (Bounce)
Driving
Sequential
Operation
Unload Nails:
To unload nails, simply pull the follower to the rear of the
magazine and press the center lock button on the follower.
The lock will move the follower out of the way and allow
nails to slide past the follower and out of the rear of the
magazine. To release the lock simply pull the follower back
and the lock button will release and allow the follower to
move forward.
Reversible Belt Hook:
The belt hook can be changed from the left hand side of the
tool to the right hand side. To change the position, squeeze
the base of the belt hook and remove it from the tool and tool
and position it on the desired side.
6