Publicidad
Step 20
Unfold the BACK (H) and lay it over your unit.
å
Make equal margins along all the top and bottom edges
å
of the BACK (H). Push on opposite corners of your unit if
needed to make it "square".
Fasten the BACK (H) to the top and side edges of your unit.
å
Use nineteen BLACK 9/16" LARGE HEAD SCREWS (1S).
Finish fastening the BACK to your unit using the NAILS (1N).
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHT (C2) and SHELVES (E2).
NOTE: Perforations have been provided for access through
å
the BACK. Carefully cut out the holes needed.
BLACK 9/16" LARGE HEAD SCREW
(19 used in this step)
www.sauder.com/services
1S
These holes must line up
over the UPRIGHT (C2).
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
H
These holes must line up
over the SHELVES (E2).
423004
1N
NAIL
(21 used in this step)
1S
Page 25
Publicidad
