Johnson Pump SPX Ultra Ballast Manual Del Usuario página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
Ultra Ballast — Self-priming, flexible impeller pump
flange mounted to DC motor 12/24 V
Typical applications
The Ultra Ballast Pump has been de-
signed to pump water into ballast tanks.
When reversed it will also pump water
out of them.
Design features
Body:
Impeller:
Seal:
O-ring:
Connection: 1/2" Internal BSP/NPT
Liquid
temperature: Max +55°C
Motor:
Shaft:
Bearings:
The motor is ignition protected according
to ISO 8846 (Small craft
- Electrical devices - Protection against
ignition of surrounding flammable gases).
Type designation
Type
F4B-11(BSP)
F4B-11 (BSP)
F4B-1107 (NPTF) 12V 10-24690-03
F4B-1107 (NPTF) 24V 10-24690-04
Original instructions
Bronze
MC 97 rubber.
Lip seal, NBR rubber
NBR rubber
or 1" hose (ø 25 mm)
0,25 kW, 12/24 V DC
with built in thermal
protection
Total enclosed
Reversible
Stainless steel
Permanent lubricated,
sealed, ball bearings
Part No
12 V 10-24690-01
24 V 10-24690-02
Pressure and capacity data
(based on water at 20°C and at nomi-
nal voltage of the motor)
draw
Bar kPa psi l/min USGM 12 V 24 V
Cont. duty
0
0
0
52
0,1
10
1,4 51
0,3
30
4,2 47
0,6
60
8,5 42
Intermittent duty
0,9
90 12,8 36
1,2 120 17,1 28
1,5 150 21,3 18
Fuse required
Installation and maintenance
Installation
Pump should be mounted in a dry, cool
ventilated location.
Pump may be mounted in any position
without loss of efficiency; however, it is
suggested that the pump head be down if
vertical mounting is desired. Mount motor
as close as possible to power source to
obtain full voltage.
The pump should be installed so that the
motor is protected from rain, wash down
or bilge water.
Please note that pump body can be turned
180° in relation to motor. This changes
flow direction.
When using a vac-on-switch, mount it
on the connection on the inlet side of the
pump. When using a pressure switch,
mount it on the connection on the outlet
side of the pump.
Don't handle diesel fuel or other mineral
oils with this pump. (For these liquids use
pump type F4B-19)
This pump cannot run against a closed
outlet. Risk for overheating.
> English
Ampere
13,7 12,5 A 6,5 A
13,5
13 A 7,0 A
12,4 14,7 A 7,5 A
11,1 16,5 A 8,0 A
9,5
17,5 A 9,1 A
7,4
19,7 A 9,5 A
4,7
21 A 10,0 A
25 A 15 A
7

Publicidad

Tabla de contenido
loading

Tabla de contenido