Window Requirements - GE ASH08 Manual Del Propietario E Instrucciones De Instalación

Window Installation Instructions
1

WINDOW REQUIREMENTS

• These instructions are for a standard
double-hung window. You will need to
modify them for other types of windows.
• The air conditioner can be installed
without the accordion panels if needed
to fit in a narrow window. See the
window opening dimensions below.
• All supporting parts must be secured
to firm wood, masonry or metal.
• The electrical outlet must be within
reach of the power cord.
8,000 BTU models
25" to 36"
(With accordion panels)
20" min.
(Without accordion panels)
10,000 and 12,000 BTU models
26" to 39
(With accordion panels)
22 1
(Without accordion panels)
14" min.
" min.
15 1 ⁄
4
"
1 ⁄
2
" min.
⁄
4
STORM WINDOW REQUIREMENTS
2
A storm window frame will not allow the
air conditioner to tilt toward the outside,
and will keep it from draining properly.
To adjust for this, attach a piece of wood
to the stool.
WOOD PIECES–
WIDTH: 2"
LENGTH: Long enough to fit inside the
window frame.
THICKNESS: To determine the thickness,
place a piece of wood on the stool to
make it 1/2" higher than the top of the
storm window frame.
Attach securely with nails or screws
provided by the installer.
1/2" higher
than frame
Storm
window
frame
REMOVE THE FRONT GRILLE
3
(IF ATTACHED)
A
Remove shipping tape, if present. On
models with a slide-out air filter, remove it
(see the Care and Cleaning section) and
the screw behind it (if present) that holds
the grille in place.
On models with a
raise-up inlet grille, lift
it (see the Care and
Cleaning section) and
remove the screw
behind it (if present)
that holds the grille in place.
On some models,
open the inlet
grille from the
sides and remove
it. Remove the
screws from the
bottom or lower right corner, if present.
11
Wood
Stool
OR
OR