Remote Control - GE ASH08 Manual Del Propietario E Instrucciones De Instalación

About the controls on the air conditioner—models with touch pads.
Features and appearance will vary.
Cool on
Air Conditioner Controls
ON/OFF
Turns air conditioner on and off.
Display
Shows the set temperature, time remaining
on timer or fan speed (1–LOW, 2–MED or
3–HIGH).
MODE
Use to set the air conditioner to COOL or
FAN mode.
Increase
Use to set temperature when in COOL mode.
FAN
Use to set the fan speed to LOW (1), MED (2) or
HIGH (3).
Power Outage Recovery Feature
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. The TIMER feature

Remote Control

s
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
s
The remote control signal has a range of
up to 21 feet.
4
Fan on
v w
/Decrease Pads
Timer on
Remote Control
TIMER
ON—When the air conditioner is off, it can
be set to automatically turn on in 1 to 12
hours at its previous setting. Each touch will
set the time in hours.
OFF—When the air conditioner is on, it can
be set to automatically turn off in 1 to 12
hours. Each touch will set the time in hours.
To cancel the timer, press the TIMER pad
until the display time disappears.
Remote Control Signal Receiver
will reset to the original setting. You may need to set
a new time if desired.
s
Make sure nothing is between the air
conditioner and the remote control that
could block the signal.
s
Make sure batteries are fresh and installed
correctly—see the Care and Cleaning section.