Brizo Pascal 64900 Serie Manual De Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2
Valve body mounting:
Verify the sealing gasket (1) is present and
the notch (not shown) mates up with the
nipple (2) and cable (3). Feed the white
electrical connection (4) through the hole
in the sink or deck. Slip the copper tubes
through the hole in the sink. Make sure
the threaded mounting stud (5) faces the
front of the sink and that the sealing gasket
extends all the way through, and is not
caught on the hole edge. Move the handle
(6) so it points to the threaded mounting
stud. This indicates the valve is in full off
position and can be aligned as desired on
the sink. Slip the bracket (7) onto the copper
tubes with the plastic side up. Align the
6
1
5
2
3
8
4
9
10
small hole in the bracket (8) with the threaded
mounting stud and assemble so the plastic top
contacts the under side of the sink. Use spacers
(9) as desired to minimize threading distance.
Using the nut/wrench assembly (10), loosely
tighten the nut. Check to see that the alignment
of the handle is correct and the gasket is not
extruding "out from under" the base. Tighten the
nut securely. Important: Make sure the tubes,
nipple and threaded mounting shank are
centered in the hole and not touching the
sides of the sink.
If mounting on a stainless steel sink make
sure the stabilization plate shown in step 1 is
positioned so it can be used for the valve body.
4
Notch
to face the
back of faucet.
7

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Pascal 64901 serie

Tabla de contenido