Using The Utility; Setting Method; Settings - Pioneer SEP-C1 Manual De Instrucciones

USING THE UTILITY

USING THE UTILITY
Press the UTILITY button to display the UTILITY screen and make unit settings.

SETTING METHOD

1 Use the function buttons to select the item you wish to set
[DISPLAY/PC/LANGUAGE/GENERAL].
2 Rotate the rotary selector dial to align the cursor with the
desired setting item.
3 Press either the select down () button or the rotary selector
dial to move the  icon to the right side.
4 Turn the rotary selector dial to select the desired setting
value.
5 Press the rotary selector dial to confirm the new setting
value.
Also, to reset a setting to its default value, press the select up
() button.
MEMO
• Grayed-out CD-G and BROWSE cannot be set on this unit.
Function buttons UTILITY
BROWSE MIX EFFECT
Rotary selector dial

SETTINGS

[1] DISPLAY
Use to perform settings for center display and external output.
LCD BRIGHTNESS Displays brightness of center
OEL BRIGHTNESS Displays brightness of
LED BRIGHTNESS Displays brightness of LEDs.
SCREEN SAVE
TV STANDARD
MONITOR OUT
*1 Screen saver operation
[2] PC
The MIDI channel can be set (P. 22).
UTILITY
Select down ( ) button
display.
display A/B.
*1
After the set time without
user operation, the LCD and
OEL screens are dimmed in
order to preserve the
displays.
Sets signal format for
monitor output (PAL, NTSC
(7.5 IRE), NTSC (0 IRE).
Sets center display aspect
ratio to letterbox, full-screen,
or OFF.
• The screensaver operates when five minutes have passed
without a track being loaded in either controller.
• The screensaver also operates after 100 minutes passes
without any button input when either one or both of the
controllers is in pause mode (including cue standby or END
display).
• The screen saver is disabled when a track is set with DJ
software other than DJS.
• During operation of the screensaver, pressing a button or
performing any other command operation will cancel the
screensaver.
Factory
default setting
ON
NTSC (7.5
IRE)
OFF
25
En