Initial Use; Installing The Lamp; Adjusting The Lamp - LIVARNO LUX 287695 Manual Del Usuario

Your lamp is now ready for use.
Note: Only adjust the lamp while it is switched off.
You can adjust the LED desk lamp to the required lighting conditions.
To do so, use the 3 joints:
1. Swivel joint with lamp base
2. Lower tilt joint: Used to move the lamp arm
3. Upper tilt joint: Used to move the lamp head
4. Swivel joint in the lamp head
7695_livx_Schreibtischleuchte_Content_US.indd 11

Initial use

Remove all of the protective film from the LED desk lamp.

Installing the lamp

Place the LED desk lamp on a flat surface with the back towards
you.
Connect the power adapter
back of the lamp.
Plug the power adapter

Adjusting the lamp

in both directions from the midpoint.
in both directions.
to the power socket
9
into a properly installed outlet.
9
: The lamp arm
7
: Used to turn the lamp head
1
on the
8
can be turned
2
up or down.
2
up or down.
1
1
US-EN 11
22.03.18 16:0