Service And Maintenance - Festo DGC-HD Instrucciones De Utilizacion

DGC-HD
For precision adjustment of the stroke:
Warning
The DGC-HD will be damaged if the DGC is operated without the stop sleeve (H) and the
lock nut (K).
• Assemble the cushioning components together only with the stop sleeve (H) and the
lock nut (K).
1. Loosen the lock nut (K).
2. Screw the cushioning element in or out.
For reasons of stability, distance d (
the values in the following table.
3. Tighten the lock nuts (K) with the following tightening torque.
Size
Distance d
Tightening torque
Tab. 5
If the effective load or dynamic response is modified:
• Check whether other cushioning components are required.
7

Service and maintenance

For cleaning and maintenance:
• Clean the band system and guide rail as required with a soft cloth.
Any media which will not damage the material may be used as cleaning agents.
• Avoid cleaning agents which will damage the belt system, which is made of PU.
Excessive rubbing or the use of grease-solvent cleaning agents (e.g. soap suds) will damage the
grease layer.
Note
The lubrication interval S
• Halve the lubrication interval S
– dusty and dirty environment
– nominal strokes 2000 mm
– speeds 2 m/s
– positioning profile: Z delta operation (frequent acceleration and braking)
– ambient temperatures 40 °C
– product has been in operation for 3 years.
If more than one of the above criteria are simultaneously met, the normal lubrication
interval must be divided by four.
26
Fig. 12) must not exceed
18
[mm] 27.3 ... 52.3
[Nm] 20
is dependent on the load acting on the product.
int
(
int
K
Fig. 12
25
31 ... 56
35
Fig. 13) if any of the following situations apply:
Festo – DGC-HD – 1304NH English
H
40
41 ... 76
60