Tripp-Lite PDU3VSR Serie Manual Del Propietário página 8

Digital Load Meter
2 Receptacle Current/IP Show Button
(Model PDU3VSR & PDU3XVSR Only):
This button
B
the current for each individual outlet.
Pressing this button once will display
the current for the first individual outlet,
located nearest the input cord. The
LED for Phase 1
this outlet is included in the Phase 1
outlets) as will the LED located next to
the outlet itself and the total current
for that outlet will display in amps in
the LED Amps display
button a second time will produce the
same results for outlet 2, pressing a
third time for outlet 3 and so on through
all the outlets.
Note: The LED for Phases 1, 2 and 3
outlets and their respective Phases. Outlets 1-8 will flash Phase 1 LED
Phase 2 LED
E
(For All Models): If you press and hold this button
IP Address assigned to the unit in the LED Amps display
assigned. If this is the case, "no address" will display, one letter at a time. If there is an IP
Address programmed, the address will display 1 digit at a time with dashes (-) representing
dots or periods (.).
201104185 93-2906.indb 8
can be pressed to show
will flash (because
D
. Pressing this
C
, , and
D E
and outlets 17-24 will flash Phase 3 LED
L 1
F
E
D
will all flash accordingly as you move between
F
, outlets 9-16 will flash
D
.
F
for 4 seconds you can display the
B
. The default is no address
C
L 2
8
B
C
A
L 3
5/18/2011 1:36:03 PM