Master Forge BG1793B-A Manual De Instrucciones página 17

NATURAL GAS CONVERSION
9. Remove the 3 main burner control knobs
by grasping and pulling out. Insert the
supplied slotted screwdriver (JJ) into the hole
of each main burner control valve stem as
shown. Rotate the stem counterclockwise
(to the left) as far as it will go. The stem will
now be set in the NG position.
Reattach the control knobs.
Hardware Used
Slotted
JJ
screwdriver
10. Use the 17 x 19 mm wrench (GG) to
remove the LP hose and regulator from
the manifold. Attach the Natural Gas
Hose (sold separately) and tighten it with
the wrench.
Hardware Used
17 x 19 mm Wrench
GG
10 ft. Natural Gas Hose
(Sold separately)
9.1
9.2
x 1
10
x 1
x 1
17
LP hose & Regulator
10 ft. Natural Gas Hose