illy Francis Francis X1 Manual De Instrucciones página 39

making coffee after generating steam
While the machine is dispensing steam, the temperature LED will be
1
steadily lit (GREEN) .
To switch the machine back quickly to the coffee mode, carry out the
following steps:
2
- Press the coffee switch down
- During the cooling down phase (approx. 10 minutes unaided) the
LED will flash (BLuE).
- Place a container beneath the steam wand
- Discharge steam by turning the steam knob counterclockwise
until the machine emits a brief beep.
- The LED will become steadily lit (BLuE)
- Close the steam knob by turning it clockwise
- The machine is again ready to make an espresso.
If you do not carry out the steps just described, it will take a lot longer
to bring the machine back into the coffee brewing mode.
In this case, carry out the following steps:
2
- Press down the coffee switch
- During the cooling down phase (approx. 10 minutes) the LED will
flash (BLuE).
- The machine will emit a brief beep.
- The LED will become steadily lit (BLuE)
- The machine is now ready again for making espresso.
.
3
.
4
5
.
6
.
.
5
.
1
Steadily lit - GREEN
3
5
Steadily lit - BLuE
EN
2
flashing - BLuE
4
6
35