T260 Pick & Place - jbc RMSE-C Serie Manual De Usuario

T260 Pick & Place
This tool helps place and remove SMDs of any size thanks to the suction provided by the station.
Pick & Place
Ref. T260-A
Choose the suction cup that best fits the component (Maximum working temp.: 250ºC / 482ºF):
Insert the needle
with the appropriate
cup for a correct
suction process.
Operation
1. Suction
Once activated
the suction button,
cover the pen hole
with your finger and
pick the component.
Press the button to
start/stop the suction
You should avoid the
needle to stick out of
the lower part.
2. Release
Lift your finger
to release the
component on the
appropriate place.
w w w.jbctools.com
11