Virutex FC16S Manual De Instrucciones página 7

Maximum grip of the clamp vises...............13 mm
Side movement of the bit over
thickness of door...................................+/- 15 mm
Weight.......................................................14 Kg
2. USE
The FC16S portable lock mortiser is an electrical tool,
for the trimming of mortises to mount door locks,
mortise assemblies, etc.
3. MACHINE HANDLING SAFETY
INSTRUCTIONS
Ensure that the person who is to use
this machine reads these OPERATING
INSTRUCTIONS and the enclosed GE-
NERAL SAFETY INSTRUCTIONS LEAFLET
carefully and understands them before
starting work.
- Before connecting the machine, ensure that the
power supply voltage corresponds to that indicated
on the characteristics plate.
- To change the bit or carry out any other operation
close to the cutting head, disconnect the machine
from the mains.
- Use safety goggles when working with the tri-
mmer.
- Do not start the motor if the machine chassis has
been removed.
- Check the power supply cable to make sure it does
not twist during use.
- Always start the trimmer using the main switch
lever.
- Once the trimmer has been placed on the part to
be trimmed, always move the tool using the carriage
advance crank handle. Never push it by hand or with
extraneous tools.
- Ensure that the motor is at a complete standstill
before removing the trimmer from the completed
mortise.
- Always use bits of the correct diameter, correctly
mounted on the serrated axis.
- Never use bits that are incorrect, defective or in
bad condition. Use only authentic VIRUTEX bits and
spare parts.
4. STANDARD UNIT
The following elements are included in the box:
- Lock mortiser FC16S
- Service keys.
- Detachable height bar in 4 sections and a door
limiter.
- Mortising trimmer bit, 16 mm diameter.
- Four clamp vise protectors for precise jobs.
- Operating Instructions and miscellaneous docu-
men-tation.
5. ASSEMBLING THE CARRIAGE
ADVANCE HANDLE
Check that the trimmer is disconnected
from the mains.
- Match the rectangular carriage forward handle
slot "A" to the planes of the shaft "B". Fit washer "C"
and screw "D", as shown in (Fig. 1). Tighten screw
"D" with spanner "F", to hold the carriage advance
handle in place.
- MAKE SURE NOT TO KNOCK THE SURFACE OF
ADVANCE HANDLE "A".
6. MOUNTING THE CUTTING TOOLS
Check that the trimmer is disconnected
from the mains.
- The mortising trimmer is supplied with a 16 mm dia-
meter bit mounted on the end of the spline shaft.
To change the bit, lock the spline shaft by its planes
with key "E1" (Fig. 2), unscrew the bit "G" with key "F"
and replace with one of the required diameter.
7. SWITCH
Cut-out box "FI" (Fig. 7) is equipped with lever "Y"
for starting up the machine and lateral fixing stop
"Z" (Fig. 7, 11). To start it up, activate fixing stop "Z"
and, without releasing it, push forward lever "Y", thus
keeping the machine running.
When lever "Y" is pushed forward with the machine
running, stop "Z" loosens automatically and the
machine comes to a halt.
The switch's fixing stop "Z" prevents the machine
from starting up accidentally.
8. ADJUSTING THE TRIMMING WIDTH
- Measure the widest point, "N", of the lock box,
including any protuberance it may have (Fig. 4).
7