Preparations; Remote Commander - Sony BMZ-K1 Instrucciones De Manejo

PREPARATIONS

Connection
Plug in the AC power cord to the AC outlet after all other
connections are made.
1 Connect the speaker cords to the speakers.
Connect the gray cords to the + terminals and the cords
with black stripes to the - terminals.
En
2 Connect the speakers to the main unit.
Connect the right speaker (marked with "R") to the
SPEAKERS R terminals and place it on the right side of
the unit. Connect the left (marked with "L") to the
SPEAKERS L terminals and place it on the left side. The
speaker cords with the black stripes go to the 9 terminals.
4
3 Connect the supplied antennas.
Connect the FM antenna to the FM 75 Ω terminal and the
AM antenna to the AM LOOP jack.
AM antenna
FM antenna
4 Connect the AC power cord to an AC outlet.
When the AC power cord is connected to a wall outlet for
the first time, DEMO appears in the display.
To deactivate the DEMO, press TITLE.
Speakers
•Do not short-circuit the 0 and 9 speaker cord leads.
•Do not leave objects generating magnetism or objects
affected by magnetism near the speakers.
Antennas
Keep antennas away from metallic objects, electrical
equipment and cords.
•FM antenna: Extend fully and position for the best
reception. If reception is poor, connect an optional outdoor
antenna to the FM 75 Ω terminal. Note that, when connecting
an optional outdoor antenna, use an adaptor as required.
•AM antenna: Rotate to find best reception.

Remote commander

Detach the battery compartment lid at the rear of the remote
commander and insert two R6 (size AA) batteries with correct
polarity.
•Replace the batteries with new ones when the operational
distance between the remote commander and main unit
becomes shorter.
•Remove the batteries if the unit is not going to be used for
an extended period of time.
•The remote commander may not operate if it is used under
intense sunlight or if its line of sight is obstructed.
R6(AA)