Panasonic GP-US932CSXE Manual Del Usuario página 24

Step 1
Select "EXPAND", and then press the [SEL] button.
The "D-RANGE LEVEL" screen appears.
→
[WHITE CLIP] Adjusts the white clip level
Be sure to view a waveform monitor or a color video monitor when the white clip level is adjusted by pressing the [e] or [f]
button.
When the level indicator moves in the "+" direction, the level becomes higher, and when the level indicator moves in the "–"
direction, the level becomes lower.
Important:
• When "D-RANGE" is set to "EXPAND", the white clip level adjustment is disabled.
[FLARE COMP] Performs flare compensation
Selection of "ON" or "OFF" (default) determines whether or not to perform the flare compensation.
When "ON" is selected, flare is reduced.
[DNR] Selects the level of the digital noise reduction function
The digital noise reduction function reduces noise. The level is selectable from the following:
LOW (default): The low level of digital noise reduction is performed. (small residual image)
HIGH: The high level of digital noise reduction is performed. (large residual image)
OFF: The digital noise reduction function is disabled.
[MATRIX] Adjusts the hue and chroma
Be sure to view a vector scope or a color video monitor when the hue and chroma adjustment is performed.
"SCENE FILE" screen
** SCENE FILE 1 ** P2
LABEL: ................
FLARE COMP
DNR
MATRIX *USER
CHROMA GAIN .....
....
TOTAL PED
FILE LABEL *OFF
AWC MEMORY
RET END
Step 1
Display the color to be adjusted in the screen center as
large as possible.
Step 2
Select the axis close to the target color with use of
"MATRIX" on the "SCENE FILE" screen. The axis is select-
able from the following:
USER (default), B-Mg, Mg, Mg-R, R, R-Ye, Ye, Ye-G, G,
G-Cy, Cy, Cy-B, B
24
"MATRIX" screen
B PHASE
OFF
LOW
... 160
B GAIN
|
.... 76
|
USER AREA
1
RET END
Step 2
Press the [e] or [f] button to adjust the dynamic range
expansion level.
** MATRIX ** USER
.... ....
0
|
+
−
.... ....
0
|
+
−
*
Step 3
Press the [SEL] button after axis selection.
The "MATRIX" screen appears.
→
Step 4
To perform fine adjustment, adjust "GAIN" (chroma) and
"PHASE" (hue) by pressing the [e] or [f] button.
** MATRIX ** USER
Cy/Cy-B PHASE .... ....
0
|
.... ....
Cy PHASE 0
|
.... .... 0
Cy-B PHASE
|
Cy/Cy-B GAIN .... ....
0
|
.... ....
Cy GAIN 0
|
.... ....
Cy-B GAIN 0
|
USER AREA *
RET END