Perry Easy Program Instrucciones De Instalación, Programación Y Modo De Empleo página 27

2.3 - Chronothermostat installation
•Disconnect the power supply from the device
•Fasten the base of the chronothermostat to the recessed box
(or to the wall) via the paired holes (fig. 5):
A-A for a round box (60 mm diameter) with clips
B-B for a round or square box with screws
C-C for a rectangular box (3 places) with screws
N.B. : fig.5, " " = removable areas for wires to be inserted (only flexible ones) D
•Implement the electrical connections as shown in the relative paragraph,
whilst paying particular attention when mounting on a wall without a
recessed box as the wiring must be placed properly for it to not interfere
when the body is closed.
•Apply the chronothermostat body to the base as shown in fig. 6.
•Press slightly until you hear the fastening teeth click into place.
•To remove the chronothermostat from the base, use a small screwdriver
to lever the fastening teeth (fig. 7).
D D
A
B
D
Fig. 5
120
Fastening teeth
Fig. 6
B
D
A B C
G
B
B
18
Fig. 7
27