Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.5 - Displaying consumption via the number of
operating hours
The chronothermostat calculates and memorises the hours of operating of the boiler (and/or
air conditioner) during the 24 hours of the previous day and from the start of the season (total
hours of operating). This information is useful for calculating the energy consumption of the
system (for indicative purposes).
Total consumption can be calculated in litres (fuel oil) or cubic metres (natural gas) by simply
multiplying the hourly consumption value (from the data plates of the boilers and burners) by
the number of hours of operating.
•
To display the operating time during the 24 hours of the previous day
requested number of hours will appear on the display (Fig. 40).
•
To display the total hours of operating from the beginning of the season
pressed for at least 4 seconds and the total hours of operating will appear (Fig. 41).
•
To reset the total hours of operating from the beginning of the season
for at least 8 seconds until the 24 hr temperature range goes off, then press
simultaneously (Fig. 42).
0000
will appear on the display (the counter that counts the boiler's
total hours of operating is reset). Release
Following the reset, the chronothermostat begins a new count of the total hours of
operating.
6.6 - Disconnecting the chronothermostat (OFF)
Keep
appears on the display
chronothermostat is deactivated (fig. 43).
In this instance, all functions of the chronothermostat are disabled; only the current time
continues to be displayed.
Pressing
again will take you back to the previously set program.
Note: in this instance, the chronothermostat disables the anti-freeze function too.
C
and
OK
.
OFF
appears on the display, - this indicates that the
Fig. 40
: press
C
and the
Fig. 41
: press
C
: keep
C
pressed
OK
Fig. 42
Fig. 43
PROG
DAY
R
PROG
DAY
R
4 seconds
PROG
DAY
R
8 seconds
G
B
41
Publicidad
Tabla de contenido
