Perry Easy Program Instrucciones De Instalación, Programación Y Modo De Empleo página 31

5 - PROGRAMMING
IMPORTANT: all settings must be confirmed by pressing OK, otherwise the
chronothermostat returns to the previous settings after 2 minutes and any
changes made will not be saved.
After inserting the batteries or after resetting (RESET: press
seconds) all sections that are on will appear on the display, after which, the blinking digits
relative to the hour and minutes will appear, as shown in figure 13.
For the chronothermostat to work you must set the following: current hour, minutes,
day and weekly program.
5.1/A) SETTING THE CURRENT TIME: HOUR - MINUTES
Use , to set the current time. Pressing repeatedly increases or decreases the time
by one minute and keeping the key pressed activates the rapid scroll. Once the time is set
press OK to confirm.
5.1/B) SETTING THE CURRENT DAY OF THE WEEK
After having set the time, the dash pertaining to the day of the week will blink beneath number
1 (Monday) on the display (fig. 14). Select the current day (e.g. 3 = Wednesday) by pressing
and press OK to confirm.
P 01 will blink on the display (fig. 15).
5.1/C) SELECTING THE PROGRAM
The chronothermostat has 4 fixed programs (see Chapter 9 - pag. 108/109).
If one of these programs (P 01 to P 04) is suitable, press
shows the particular program, then press
dash pertaining to the current day beneath the corresponding number, the room
temperature and the 24-hour temperature range as set with the current hour digit blinking;
the chronothermostat is working
If none of the programs happens to be suitable, press
repeatedly until program P 05 appears, then proceed as described in paragraph 5.2.
simultaneously for 2
PROG repeatedly until the display
OK . The following will appear on the display: the
.
PROG repeatedly until program
Blinking
Fig. 13
PROG DAY
R
Blinking
Fig. 14
PROG DAY
R
Repeatedly
Fig. 15
PROG DAY
R
G
B
31