Perry Easy Program Instrucciones De Instalación, Programación Y Modo De Empleo página 37

5.9 - Reading the programs
Press PROG: the program in use will appear on the display as shown in the example (Fig. 28).
If the program is one of the four fixed programs (
automatically on the display one after the other (Fig. 28-29).
After reading the program, press
chronothermostat reactivates the program set initially after 2 minutes).
If P 05 has been used, the scrolling of the settings of each day will occur automatically.
After 2 minutes, program P 05 will be automatically reactivated, otherwise, keep
for at least 4 seconds.
Note: press PROG to switch from one program to another when reading programs.
When reading programs you can replace the current program and/or modify program
- To replace the current program
confirm the new selection by pressing
press OK and follow the procedure as explained in paragraph 5.2. Alternatively, if program
has been previously set , confirm by pressing
- To modify program P 05 follow the instructions explained in paragraph 5.4.
5.10 - Reset
To clear set data or if the chronothermostat shows abnormal messages on the display or
malfunctions, press simultaneously for 2 seconds:
All sections that are on will appear on the display.
Afterwards, the display will appear as in figure 13 in paragraph 5.1/A and the chronothermostat
will be ready to be programmed again.
With this operation, all program settings are lost as the chronothermostat resets the factory
settings.
P 01 to P 04 ), the settings per day will appear
OK to reactivate it (if this is not possible, the
, select the new program ( P 01 to
OK. If on the other hand, the new program
OK for at least 4 seconds.
Fig. 28
OK pressed
P 05 :
P 04 ) via PROG and
to set is P 05 ,
P 05
Fig. 29
Fig. 30
Press simultaneously for 2 seconds.
PROG
DAY
R
PROG
DAY
R
PROG DAY
R
Reset
G
B
37