IV. WHEELCHAIR USE & CONFIGURATION
G. Height Adjustable T-Arm
WARNING: These arms offer only a lock against rotation and are designed to bear a
downward force only. They will remove completely if pulled up on and cannot be used to
lift or otherwise handle the chair. Failure to comply with the instructions above may result
in the armrest accidentally disconnecting from the wheelchair and result in a fall or loss of
control and may cause serious injury or death.
How to Use Your Armrest
1. Installation
a. Slide the outer armpost into the receiver mounted to the wheelchair frame.
b. The armrest will automatically lock into place. Check to make sure the locking lever is as
shown (Fig. 2:B).
2. Height Adjustment
a. Rotate the release lever (Fig. 2:A).
b. Slide the armrest pad up or down to the desired height.
c. Return the lever to the locked position against the arm post.
d. Push the arm pad until the upper arm locks firmly into place. Check to make sure the lock-
ing lever is as shown (Fig. 2:A).
3. Removing the Armrest
a. Squeeze the release lever (Fig. 2:B) and remove the armrest.
Fig. 2
17
A
B