Need Help - Hoover BH52210 Manual De Instrucciones

Need Help?

WARNING
!
To reduce the risk of personal injury, remove battery
before cleaning or servicing.
My Cruise Cordless Vacuum won't turn on.
Your battery may not be charged. Check the Charge Level Indicator
and charge the battery if it's low. Reference the chart below to find
the charge time for your model. The battery does not come fully
charged.
My Cruise Cordless Vacuum isn't picking up well.
You may have a clogged filter. Your filter should be rinsed every 4-6 uses.
Push the dirt cup release button and remove the filter. Rinse with clear warm
water for two minutes. Let it dry for 24 hours before reinstalling it.
If your filter was dirty...
You may also have a clog in the system. Turn the top of the hose
counter-clockwise to unhook, and stretch the hose down to search
for a clog. If found, remove the clog.
23
!
My Cruise Cordless Vacuum picks up well on hard floors, but not
on carpet.
When you're vacuuming, look to see if the brush roll is spinning. You should hear it.
If you don't, roll the power switch forward past ON to turn on the brush roll.
If your brush roll is not turning on...
The Motor Protection Sensor may have been activated by an obstruction. Remove
the battery, then find and remove the obstruction. Wait a few minutes (usually about
2-5, but can take up to 30) for the unit to reset itself, replace the battery and turn on.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left
outdoors, or dropped into water, take it to a service center prior to
continuing use.
QUESTIONS OR CONCERNS?
For a Complete Troubleshooting Guide, see: Hooverhelp.com/Cruise Cordless
Do not return to store. See back of product for model number.
Contact Us: (888) 679-2121
Twitter: @HooverUSA
Facebook: facebook.com/hoover