Tabla de contenido
Publicidad
Preparing Snow Blower For Installation
1. Loosen and remove the three (3) 1/4" bolts (A,
Figure 11) the secure the chute motor (L) to the
blower. Rotate the motor counter-clockwise and
reinstall the hardware. See Figure 11
1. Remove the two (2) flanges (G, Figure 12) and
bearing (J) from the blower shaft (L).
2. Position the snow blower mount (A) onto the blower
(B) by sliding the blower shaft (L) through the
center of the mount.
3. Connect the mount to the blower by installing two
(2) 1/2" bolts and washers (E) through the bottom
set of holes as shown in figure 11. Secure with two
(2) 1/2" nuts (F).
4. Install two (2) 3/8" bolts and washers (C) through
the top set of holes as shown in figure 11. Secure
with two (2) 3/8" nuts (D).
5. Place the flanges (G) and bearing (J) back onto the
blower shaft (L).
6. Secure the flanges with two (2) 5/16" carriage bolts
(H) and 5/16" nuts (I). Tighten down the set screw
(K) into the bearing.
A
H
G
K
G
J
I
Figure 12. Snow Blower Mount
A. Snow Blower Mount
B. Snow Blower
C. 3/8" Bolt & Washer
D. 3/8" Nut
E. 1/2" Bolt & Washer
F. 1/2" Nut
Figure 11. Chute Motor Positioning
A. 1/4" Bolts
B. Chute Motor
B
D
G. Flange
H. 5/16" Carriage Bolt
I. 5/16" Nut
J. Bearing
K. Set Screw
L. Blower Shaft
Installation
A
C
L
F
ES
B
E
11
GB
Publicidad
Tabla de contenido
