Tabla de contenido
Publicidad
Installing the Actuator Mounting Bracket
1. Install the actuator mount support (B, Figure 15)
by loosely installing two (2) 3/8" X 1-1/4" bolts (G),
3/8" washers (H) and 3/8" nuts (I). See Figure 20.
2. Install the actuator mount bracket (A) using four
(4) 5/16" X 1-1/4" bolts (C), 5/16" washers (D) and
three (3) 5/16" nuts (E). Be sure to tighten down
the bolt that uses the existing body clip (F) first,
followed by the three (3) bolts that require 5/16"
nuts.
3. Tighten down the 3/8" hardware installed during
Step 1.
Removing the Upper Floor Plate
1. Loosen and remove the four (4) 5/16" carriage bolts
(B, Figure 16) and 5/16" nuts (A).
2. Remove the upper floor plate (A) from the machine.
Save the floor plate for reinstallation.
Installing the Snow Blower
Attaching the Snow Blower and Mount
1. Place the snow blower with the mount attached and
kick stand down on a flat level surface.
2. Remove the pin with lanyard (A, Figure 17) from
the latch on the attachment mount on both sides of
the machine.
2. Align the machine straight behind the mount and
drive slowely into the blower as shown in Figure 17.
3. The latch on the attachment mount (A, Figure 18)
should securely enclose around the snow blower
mount (B).
Figure 16 Upper Floor Plate
A. Upper Floor Plate
B. 5/16" Carriage Bolt
C. 5/16" Nut
A
Figure 17. Attaching the Snow Blower
A. Pin with Lanyard
A
Figure 18. Attachment Mount Latch
A. Latch
B. Snow Blower Mount
Installation
A
B
C
A
B
ES
GB
13
Publicidad
Tabla de contenido
