Preparing The Ztr - Briggs & Stratton 800X Manual Del Operador

Installation
Attaching the Drive Shaft to the Snow Blower
1. Place the key (B, Figure 13) onto the blower shaft
(A).
2. Slide the universal joint of the female end of drive
shaft (C) onto the blower shaft. Be sure to leave
1/16" clearance between the end of the shaft and
the end of the universal joint to aviod hitting the
grease fitting (F).
3. Secure the drive shaft in place by tightening down
the bolt & nut (D) and then tightening down the set
screw (E).
Preparing The ZTR For Installation
Replacing the Spring Pivot Mounts
1. Loosen and remove the 3/4" X 4-1/2" bolt (C,
Figure 14), 3/4" washer (D) and 3/4" nut (G).
2. Remove the brass bushing (E) and spacer (F) from
the old spring pivot mount (A). Discard the old
bracket.
3. Remove the spring attachment bolt, nut, washer
and jam nut from the old spring pivot mount.
4. Install the brass bushing (E) and spacer (F) into the
new spring pivot mount (B).
5. Install the spring attachment bolt, nut, washer and
jam nut onto the new spring pivot mount.
6. Secure the new mount to the machine with the
existing hardware that was removed in Step 1.
7. Repeat this process to the other side of the
machine.
Figure 13. Drive Shaft
A. Blower Shaft
B. Key
C. Drive Shaft (Female)
D. Bolt & Nut
E. Set Screw
F. Grease Fitting
12
C
D
A
F
B
E
G
F
Figure 14. Spring Pivot Mount
A. Old Mount
B. New Mount
C. 3/4" X 4-1/2" Bolt
D. 3/4" Washer
E. Brass Bushing
F. Spacer
G. 3/4" Nut
A
B
G
H
I
Figure 15. Actuator Mounting Bracket
A. Actuator Mount Bracket
B. Actuator Mount Support
C. 5/16" X 1-1/4" Bolt
D. 5/16" Washer
E. 5/16" Nut
F. Body Clip
G. 3/8" X 1-1/4" Bolt
H. 3/8" Washer
I. 3/8" Nut
ferrismowers.com | snapperpro.com
E
B
D
C
C
D
F
E