Briggs & Stratton 800X Manual Del Operador página 17

Securing the Mount to the Machine
1. With the accuator attached, extend the accuator
to its furthest point. This will lift the snow blower
mount into place so it can be secured with a pin (A,
Figure 22) on both sides of the machine. Retract
the accuator all the way in.
2. Using a 1/2" breaker bar (B, Figure 23), carefully
rotate the spring mount pivot (C) clockwise and
connect the spring assist link (A) between the
spring mount pivot and the snow blower mount (D).
3. Secure the spring assist link in place using two (2)
1/2" washers (E) and hair pins (F).
4. Carefully relieve the tension on the spring mount
pivot.
Installing the Drive Shaft
1. With the male end of the drive shaft (A, Figure 24)
inserted into the female end (B), connect the male
end to the spline shaft (C) using the quick connect
coupling (D).
A
Figure 22. Securing the Mount
A. Pin with Lanyard
C
Figure 23. Wire Harness
A. Spring Assist Link
B. Breaker Bar
C. Spring Mount Pivot
D. Snow Blower Mount
E. 1/2" Washer
F. Hair Pin
C
D
Figure 24. Drive Shaft
A. Drive Shaft (Male)
B. Drive Shaft (Female)
C. Spline Shaft
D. Quick Connect Coupling
Installation
A
E
D
B
A
B
ES GB
F
15