When Installing The Touch Unit On The Whiteboard (Without Using The Touch Unit Bracket); Installation Procedure - Epson BRIGHTLINK PRO 1460U Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

When installing the Touch Unit on the whiteboard (without using the Touch Unit
Bracket)
About installation
• There are magnets built into the back of the Touch Unit. Normally, the Touch Unit should be installed by attaching
the magnets to the screen.
• If the magnets cannot be attached to a screen, use commercially available M4 screws (x3).
• Attach the Touch Unit to the same level surface as the screen surface.

Installation Procedure

Install the Touch Unit, and then connect to the projector.
Caution
Only connect the Touch Unit to the EB-1460Ui/EB-1450Ui. Do not connect it to any other projectors or
devices.
a
Turn on the projector, and then press the [Menu] button
Using the Remote Control
b
Select Easy Interactive Function from Extended
Using the Control Panel
87
Installation Guide

Publicidad

Tabla de contenido
loading

Tabla de contenido