Introduction; Installation - Emerson Profibus Guia Del Usuario

1.

Introduction

The Profibus Module can be used with Digistart CS and Digistart IS soft starters to allow the starter to be connected to a serial
communications network using the Profibus protocol.
2.

Installation

Remove mains and control voltage from the soft starter before attaching or removing accessories.
WARNING
Install the Profibus Module using the following procedure:
1. Remove control power and mains supply from the soft starter.
2. Attach the module to the soft starter as illustrated.
3. Set the module address to match the address set in the Master configuration tool.
4. Apply control power to the soft starter.
5. Insert the network connector and power up the module.
Figure 2-1 Attach the module to the starter
Digistart CS:
Plug the module onto the side of the soft starter.
Digistart IS:
1. Line the module up with the comms port slot.
2. Press the top retaining clip of the module into the soft starter chassis.
3. Press in the bottom retaining clip.
Figure 2-2 Remove the module from the starter
Remove the module using the following procedure:
1. Remove power from the module.
2. Remove control power and mains supply from the soft starter.
3. Disconnect all field wiring from the module.
4. Push a small flat-bladed screwdriver into the slots at the top and bottom of the module
and depress the retaining clips.
5. Pull the module away from the soft starter.
4
www.controltechniques.com
Profibus Module User Guide
Issue 1