Haier ESD200 Manual Del Usuario página 11

ESD200-MANUAL 1/10/03
English
Selecting Wash Options:
For your convenience, there are three wash options available for
the wash programs: Hi-Temp Wash, Heated Dry and Upper Wash.
"SELECT" button allows you to select your desire options.
Hi-Temp Wash Option:
• This option is used only with the "POTS & PANS" wash cycle.
Note: This option is not available with "NORMAL, LIGHT and RINSE & HOLD wash
programs.
Note: When this option is selected, water temperature boosts up between
161˚F – 167˚F. "HI-TEMP WASH" temperature helps to kill bacteria, dissolve
detergents, remove sticky and greasy substances off the dishware.
Note: Due to any interruption during the wash and rinse program or low incoming
water temperature, proper water heating temperature can not be achieved
and therefore the "HI-TEMP WASH" (heating temperature) conditions may be
affected.
Heated Dry Option:
• When this option is selected, both the heater and convection fan turn on
automatically for fast drying purposes.This option can be used with
"POTS & PANS, NORMAL and LIGHT" wash programs.
Note: This option is not available with the "RINSE & HOLD" program.
Using Delay Start Option:
Follow the steps below to delay start a wash program.
1) Press the "POWER" button to turn the unit "ON".
2) Press the "DELAY" button to select the amount of time that the wash program is
delayed. For your convenience, you can select between 1 to 9 hours to delay the
wash process.
3) Select your desired wash program and option(s).
Note: Some restrictions may apply when selecting wash option(s) with wash
programs. Read "Wash Option Selecting Procedure" section on page
numbers 10-11 for more details.
Note: If you are not satisfied with the wash program and wash option(s) that you
have selected, simply press the "POWER" button to turn off the unit. To
reselect new wash program and option(s), press "POWER" button again to
turn the unit "ON". Reselect the new wash program and wash option(s).
9
11:29 AM Page 11