Silvercrest SDBK 2400 F5 Instrucciones De Servicio página 50

If the device (steam iron or stand) never-
theless falls into water, pull out the pow-
er plug immediately and only then
remove the device from the water. Do
not use the device again, and have it
checked by a specialist.
The water tank must not be filled with
water above the max marking, other-
wise it may overflow.
Never touch the device with wet hands.
DANGER! Risk of electric
shock
Lay the power cable such that no one
can step on it, get caught on it, or trip
over it.
Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Do not wrap the power cable around
the device (risk of cable damage!).
Ensure that the power cable cannot be
trapped or crushed.
To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
Disconnect the mains plug from the wall
socket...
... after every use
... if there is a fault,
... when you are not using the device,
... before you clean the device, and
... during thunderstorms.
If the power cable or the device is dam-
aged, immediately pull the mains plug
out of the wall socket.
48 GB
DANGER! Fire hazard
Use the device on a stable, level and
heat-resistant surface.
Even during short interruptions, always
place the steam iron in the stand and
never on its sole plate. It must be placed
on a stable and heat-resistant surface.
Pull out the mains plug during longer in-
terruptions or if you leave the room.
DANGER! Risk of injury
through burning
Do not touch the hot surfaces of the de-
vice.
Allow the device to cool down com-
pletely before you clean it or put it
away.
Danger due to sudden evaporation. Al-
low the device to cool down completely
before you refill it with fresh water.
Warning: risk of burns from steam and
sprayed hot water when using the
steam burst button. When using the
steam burst, always point the sole plate
towards the item of laundry or ironing
board.
The sole plate becomes very hot during
operation. Only touch the handle and
control elements of the steam iron dur-
ing operation.
Never iron items of clothing on a per-
son's body.
WARNING! Risk of material damage
Only use the original accessories.
Do not use any astringent or abrasive
cleaning agents.
Do not iron over e.g. zippers, metal but-
tons or applications that could damage
the sole plate.
Do not put vinegar, limescale remover
or any other additives into the water
tank. Additives can damage the device.