Tips & Troubleshooting - Conceptronic CMED2PRO Guia Del Usuario

ENGLISH
Movie Setup page
Repeat : Set Repeat mode.
One / Off / All / Shuffle
Main Page
: Return to the Setup Menu
Slideshow Setup page
Folder Repeat : Repeat the contents of a folder.
On / Off / Shuffle
Interval Time
: Set
slideshow.
Transition : Set a standard transition for the
slideshow.
Main Page : Return to the Setup Menu
Preferences Setup page
TV Display : Set your TV Display size.
Tv Type : Set your TV Type: PAL / NTSC.
Video Output : Select the correct video output
for the connected TV / Monitor.
OSD Language : Set
Media Player.
Configuration : Reset
factory default settings.
Main Page : Return to the Setup Menu
7. Tips & Troubleshooting
Use the tips below for troubleshooting when your CMED2PRO is not working properly:
The Power LED doesn't light up
x The power supply is not connected to the CMED2PRO. Reconnect the power supply to the
CMED2PRO.
There is no activity on the display.
x The CMED2PRO is in standby state. Press the
x The Wrong input source on your TV is selected. Change the input source.
x The Wrong video system selected. Press the OUTPUT button on your remote control to switch video
system.
x The Video cable is not connected properly. Check if the Video Cable is connected correctly.
the interval time
the OSD Language
the Configuration
30
of the
of the
to the
button on the remote control to activate it.