Locking/Unlocking Your Safe
2
3
NOTE: • If you exert excessive force on the handle, the handle will break. This feature is designed
to protect the bolts from being over powered by force.
• Green LED light comes on after you enter valid code, and remains lit during the
4-second period in which the safe can be opened.
Locking your safe
1
2
NOTE: • The 5 digit factory code cannot be deleted. However, you may add and delete additional
codes (see next page).
• If your safe does not appear to be working properly, please check to make sure you are
using NEW alkaline batteries before contacting SentrySafe Customer Care.
Enter the 5 digit factory code on the back of this owner's
manual. Then press the "Prog/Enter>>" key.
The unlocked padlock icon (
You will have 4 seconds to turn the handle to
unlock your safe.
Rotate the handle downward to open the door.
This may take a limited amount of force if you have
a water-resistant safe.
A. Close the door, and pull the handle upwards until the handle
is horizontal.
For water-resistant units, additional pressure to the
front, left side of the door may need to be applied
prior to rotating the handle.
B. FOR DUAL KEY LOCK, insert key, push in lock cylinder, and
turn key to left to the locked position, then remove the key.
5
) appears.