Gas Burners; Switching On; Safety System; Switching Off - Siemens ER6 PT Serie Instrucciones De Uso

Gas burners

It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to work
correctly. Do not swap the burner caps around.

Switching on

Switching on a burner:
Connect the appliance by means of the main switch. The
1.
main switch indicator lights ups.
Press the chosen burner control knob and turn it
2.
anticlockwise to the maximum power setting.
While the control knob is still pressed down, sparks are
produced on all burners. The flame ignites.
Release the control knob.
3.
Turn the control knob to the required setting.
4.
If it does not come on, turn the control knob to the off setting
and repeat the steps above. This time, press and hold the
control knob for longer (up to 10 seconds).
:
Risk of deflagration!
If after 15 seconds the flame does not ignite, switch off the
burner and open a nearby window or door. Wait at least one
minute before trying to switch the burner back on.
Note: If no burner turns on after pressing the main switch, the
appliance automatically turns off after one minute.

Safety system

Your hob is equipped with a safety system (thermocouple) that
cuts off the gas when the burners are accidentally switched off.
14
To ensure that this device is active:
Switch on the burner as usual.
1.
Without releasing the control knob, press and hold it down
2.
firmly for 4 seconds after lighting the flame.

Switching off

Switching off a burner: turn the control knob clockwise to the off
setting.
Switching off the hob: after finishing cooking, turn all the
controls to setting 0 and turn off the appliance with the main
switch. The main switch indicator will be turned off.

Power levels

The progressive control knobs can be used to control the
power needed, from minimum to maximum power.
Ú
Setting Control knob off
High flame ™ Maximum capacity or aperture and elec-
tricity on
Low flame š Minimum capacity or aperture
For dual double-flame burners, the inner and outer flames can
be controlled separately. The available power levels are as
follows:

Childproof lock

To activate the childproof lock:
The hob must be off. Press the main switch for a few seconds.
The display indicator shows the childproof lock
hob cannot be switched on.
Inner and outer flame on full
power.
Outer flame on low power,
inner flame on full power.
Inner flame on full power.
Inner flame on low power.
¨´ . Now the